Features
of your 10" Westcoast-Mxtbars RG15
Fitment:
* 2015-2020 ROAD GLIDES
for 2014 and earlier bikes see MX-TBARS Category
* 2018 and earlier STREET GLIDES
VERY IMPORTANT: ABS and NON ABS Road glides can use these bars with the current stock cables and wiring.
Coating: RAW
Top Crossbar:
- 5 1/2" spread in the middle of the handlebar. Then bends and rises up
2" and then the 1-1/4" tubing is swaged (tapered) down to
1"diameter. (Fits conventional controls)
- Both sides have
1/2" holes punched for internal wiring.
- Cross width is 31 1/2" across and pullback is 3 1/2".
- Your Wrist angle will be at a 18 degree angle Cross bar is welded to sit flat
on a 28 degree rake
- The (2) - 3/4" holes in middle of the bar are made to be centered for
the 3 1/2 spacing of the risers.
The
throttle side tubing at 1" is honed out and notched for fly by wire.
Risers: 3 1/2" spacing between risers.
(Fits conventional top triple tree clamps). 1/2" x 5/8" oval holes are 1
7/8" up from the bottom for internal wiring.
Recommendations:
- Heavy Duty Bushings FOR ROAD GLIDE
- Grade 8 or Grade 9 (L9) bolts
Keynote:
- These Handlebars are measured by overall height 8 inch risers with the 2 inch
rise on the top cross bar equals 10 inches.
- 4 total weld points
-2 holes will need to be made in the nacelle plastic to pass through and
bolt down directly to the triple trees.
- On road glides the nipple on the
underside of the vibration dampener on the inside part of the controls
must be cut off to fit on our bars.
Here is RG15 Nacelle Cutout template link.CLICK HERE TO DOWNLOAD!
