Features of your 18" Westcoast-Mxtbars Metal: 1080 mild gauge steel tubing with .125 wall thickness
Coating: RAW Color: N/A *Powdercoating ends 4"es before each side for easier installation of your controls Top Crossbar: - 5 1/2" spread in the middle of the handlebar. Then bends and rises up 2" and then the 1-1/4" tubing is swaged (tapered) down to 1"diameter. (Fits conventional controls) - Both sides have 1/2" holes punched for internal wiring. - Cross width is 31 1/2" across and pullback is 3 1/2". - Your Wrist angle will be at a 18 degree angle Cross bar is welded to sit flat on a 28 degree rake - The (2) - 3/4" holes in middle of the bar are made to be centered for the 3 1/2 spacing of the risers.The throttle side tubing at 1"� is honed out and notched for fly by wire. Risers: 3 1/2" spacing between risers. (Fits conventional top triple tree clamps). 1/2"� x 5/8"� oval holes are 1 7/8" up from the bottom for internal wiring. 3/4" diameter cross bar welded at the bottom of the risers above the internal wiring holes. It is measured 4"� up from the bottom end of the riser. (This makes the handlebar compatible with road glides).
Riser Bungs: - These bungs are designed to be a steel 1 piece, 3-tier design. First tier fits inside the 1 1/4"� tubing. Second tier meets flush with the bottom of the risers and is TIG welded bonding the bung to the riser. The third tier widens to 1 1/2"� and is hollowed out 1/4"� deep. This eliminates the need of a traditional washer setup, the handlebar bushing fits perfectly inside the custom bung. Recommendations: - Heavy Duty Bushings - Grade 8 or Grade 9 (L9) bolts Keynote: - These Handlebars are measured by overall height 16" risers with the 2 " rise on the top cross bar equals 16"es. - 6 total weld points